Platform Adaptation
Our existing sensor and embedded platforms adapted to your signals, outputs, protocols, enclosure and calibration, built on hardware and firmware that are already validated.
Custom Embedded Systems for OEM Applications
Our sensor and embedded platforms, adapted and validated to an OEM's requirements, with the engineering support to take a product from requirements to production.
Engineering you can build on.
What We Offer
Engineering Consultation
Design reviews, fault finding, requirements and test planning, and documentation for teams developing their own products.
Clean-Sheet Development
Taken on where the requirements and the program justify a new design.
A Complete System
Each product is engineered as a complete system: PCB hardware, software and firmware, enclosure, and documentation (datasheets and application notes covering installation and setup).
PCB Hardware
Schematic design, component selection and PCB layout for every environment the product will encounter: operating, storage and transit.
Software and Firmware
Embedded firmware developed and verified against the requirements, plus the configuration, calibration and production-test software every unit passes through before it ships.
Enclosure
Material selection, sealing, mounting and connector interface, developed with the PCB and designed for manufacture.
Documentation
Datasheets, manuals and application notes covering installation and setup.
How a Project Runs
Specified, analyzed, verified, validated. Every product follows the same documented path, from functional requirements and failure analysis to verification and validation.
Requirements Capture
Functional requirements, operating and non-operating environment, interfaces and volumes, agreed and documented before design begins.
Architecture
The closest existing platform is selected, or a new architecture is defined, with the technical risks identified at the outset.
Design and Review
Schematic, PCB layout, firmware and enclosure developed as one system, with risk mitigation through failure mode analysis and a design review before each release.
Prototype and Verification
Prototypes built and tested against the verification plan.
Validation
The complete product tested to the validation plan.
Production Readiness
Production test fixtures, calibration and test procedures, and released documentation, all under revision control.
Production and Support
Final assembly, programming, calibration and test done in-house on every unit, with each change managed through a new revision.
Production
In-house production covers final assembly, programming, calibration and test at the volumes we build today. Higher volumes and specialized testing may be arranged with partner manufacturing and accredited laboratories, set up per program.
Standards
Our development process is being aligned with ISO 9001:2026 for quality management, MISRA C:2023 and MISRA C++:2023 for embedded software, and RTCA DO-254 and DO-178C for airborne hardware and software design assurance. Where a program requires formal certification or compliance evidence, it is scoped with the customer at the outset.
Over the Past Year
Over the past year: new product development and firmware, a provisional patent application for WSCAN's Autonomous ECU Recognition, continuous product improvement, product and process compliance, testing, documentation, and production rates increased to support scaling.
Bench: calibration and testPhoto slot (real photo; process yes, internals no)
Start a Project
Describe the application and the volumes you anticipate. Drawings or requirements may be attached, but they are not required to start. We can exchange NDAs before any details are shared.